no image

4 simple techniques in order not to slip

Our tips suitable for vehicles with any type of drive when driving on snow, mud and any other slippery surface, whether sand or a layer of fallen autumn leaves.Sergey Kanunnikov “driving”Expert

Less gas!

The main principle of riding on any slippery surfaces — properly dosed cravings. If the drive wheels have begun to slip, try to gradually decrease your cravings to not give wheels to scroll and was finally not clog with snow or dirt tires, and not to “bury” the car.

In a car with a manual transmission it is important to feel the line beyond which the engine will stall, correctly choose the gear. Drogas car with a manual transmission on slippery surfaces with slip, you need to quickly jump from first to second gear (on machines with machines is, in fact, a winter mode, which on many models, you can enable forced). And then when the car was already moving on a slippery stretch pull again, should be as stable as possible — no sudden additions and reduce gas.

On slippery surfaces to turn the wheels over smoothly and, as far as possible, at minimum angles.On slippery surfaces to turn the wheels over smoothly and, as far as possible, at minimum angles.

Just right!

On any slippery surfaces conducive to spin, the wheel should rotate smoothly and at minimum angles. To leave snow, sand, dirt much easier with the wheels straight than twisted, which increases rolling resistance. And when the car more or less confident come on, you can rotate the wheel, but without sharp movements and great angles, choosing, if possible, the corresponding trajectory. In the snow sometimes before you start, it is useful to place a couple of times to crank the wheel left and right, as if to create the launch pad. But it is necessary to start still straightforward.

Sometimes to go forward, at first quite a bit back.Sometimes to go forward, at first quite a bit back.

Not forward? We will go back!

When the car started to slip already thoroughly, add gas, more and more spinning wheel of the stopped car is pointless. Only deeply dug, and disfiguring at the same time overheating the clutch or automatic transmission.

Not forward? Try back! Sometimes it is enough to drive off only some of inches, and this “springboard” is enough to pass the critical section (remembering the smooth-drawn and most direct wheels!). This procedure can be done several times. Especially this technique (in the driver’s slang — swinging) effective on a car with a manual transmission. With skillful quick switching from reverse gear to first to get the machine to gain confident it is possible very often.

Auto boxes do not allow buildup. What, by the way, do not forget, being on a dangerous, slippery area. But you go a bit back to overclocking is certainly worth a try.

If the machine is already up, push on the gas pedal on the front of the transmission is meaningless, and harmful to the transmission.If the machine is already up, push on the gas pedal on the front of the transmission is meaningless, and harmful to the transmission.

Only forward!

Sometimes it’s easier to avoid the slippery area — say, snow-covered rise — with acceleration that is called progress. If we are talking about snow-covered area, it can be done, just knowing that under the snow there is no obstacles: large stones, open wells or perhaps rusty Armaturen, that is a familiar place. Then, gaining speed, on the second or third gear and not changing (in an extreme case, only need a little and very slowly adding the gas) traction, with the wheels as straight as possible forcing in snow, or mud barrier.

These simple techniques do require training, which is best done in advance — before the car stalled hopelessly. You’ll feel a lot more confident, and the car objectives be.

  • How not to drive in bad weather, find out here.

4 simple techniques in order not to slip

Our tips suitable for vehicles with any type of drive when driving on snow, mud and any other slippery surface, whether sand or a layer of fallen autumn leaves.

4 simple steps to буксовать4 simple technique in order not to slip

Our tips suitable for vehicles with any type of drive when driving on snow, mud and any other slippery surface, whether sand or a layer of fallen autumn leaves.

4 simple ways to not buctouche: “Behind the wheel”

Залишити відповідь